LAS0070S-P
Nd:YAG microLaser with 3D-printed chassis
The same cavity and electronics as the LAS0070S in a 3D-printed PETG chassis: smaller and more affordable.
Built for prototypes and labs on a tight budget. It runs from a USB power bank, no mains needed. The cavity is monolithic: the Nd:YAG rod, Q-switch and mirrors are a single bonded piece that does not drift out of alignment in transport.
Price on request
Specifications
| Type | Nd:YAG, flash-lamp pumped |
|---|---|
| Wavelength | 1064 nm |
| Pulse energy | Up to 140 mJ, adjustable |
| Pulse width (FWHM) | 10 ns |
| Measured stability | RSD 1.46 % over 10 consecutive shots |
| Q-switch | Passive |
| Repetition rate | 1 shot every 35 s |
| Triggering | Manual button or TTL input |
| Sync | TTL output relative to the flash lamp |
| Mounting | SM1 threaded tube (Thorlabs) |
| Power | USB power bank or wall adapter |
| Chassis | 3D-printed PETG |
| Size | 78.5 × 100.5 × 108 mm |